Common Faults and Maintenance Tips for Distribution Cabinets
2025-12-12
Common Faults and Maintenance Tips for Distribution Cabinets—Also known as distribution boxes, distribution cabinets are a general term for motor control centers. A distribution box is a low-voltage distribution device that assembles switching devices, measuring instruments, protective relays, and auxiliary equipment into enclosed or semi-enclosed metal cabinets or panels according to electrical wiring requirements. Distribution boxes feature small size, easy installation, special technical performance, fixed location, flexible configuration options, no restrictions on site conditions, widespread application, stable operation, high space utilization, minimal footprint, and environmental benefits.
Distribution cabinet maintenance
I. Circuit breaker fails to close: 1. Press the closing button; the closing coil is energized but does not operate—replace the undervoltage coil. 2. The closing button has poor contact—replace the closing button. 3. The fuse in the control circuit is blown—replace the fuse. 4. The circuit breaker lacks stored energy—check that the motor voltage is greater than 85%. 5. The closing electromagnet’s voltage is too low—ensure the closing electromagnet’s voltage is greater than 85%. 6. The closing electromagnet is damaged—replace the closing electromagnet. 7. Poor contact in the secondary circuit of the drawer-type circuit breaker—pull out the drawer-type circuit breaker, then push it back into the closed position and check whether the secondary circuit connections are secure. 8. The rotary switch is in the stop position—turn the switch to the energized position.
II. The main switch of the incoming feeder cabinet cannot be tripped: 1. The trip button has poor contact—replace the trip button; 2. The trip coil is burned out—replace the trip coil.
3. If the main reactive power meter reverses or fails to rotate: 1. The power factor due to capacitor compensation is too high—adjust the capacitor compensation to between 0.92 and 0.97; 2. The phase sequence of the transformer’s incoming lines is incorrect—rearrange the phase sequence; 3. The voltage and current circuits are normal—replace the reactive power meter.
4. The capacitor bank cannot switch automatically: 1. The current sampling signal line is not connected—connect the current sampling signal line properly; 2. The fuse in the compensation controller is blown—replace the fuse; 3. The voltage is too high, and the controller displays overvoltage—adjust the overvoltage protection setting; 4. The current is too low, and the controller displays leading—after increasing the current, the system will operate automatically; 5. The capacitor bank’s compensation meter displays overvoltage—reset the voltage value.
5. If the meter with drawer-type wiring does not rotate: 1. Poor contact of the secondary connector—re-adjust the contact blade of the secondary connector; 2. Current and voltage are normal—replace the meter.